SOYO SY-V6BE+ quick start Quick Bios Setup, Select Standard Cmos Setup, Select Load Setup Default

Page 11

SY-V6BE+Quick Start Guide

3 Quick BIOS Setup

This mainboard does not use any hardware jumpers to set the CPU frequency. Instead, CPU settings are software configurable with the BIOS [SOYO COMBO SETUP]. The [SOYO COMBO SETUP] menu combines the main parameters that you need to configure, all in one menu, for a quick setup in BIOS.

After the hardware installation is complete, turn the power switch on, then press the <DEL> key during the system diagnostic checks to enter the Award BIOS Setup program. The CMOS SETUP UTILITY will display on screen. Then, follow these steps to configure the CPU settings.

Step 1. Select [STANDARD CMOS SETUP]

Set [Date/Time] and [Floppy drive type], then set [Hard Disk Type] to “Auto”.

Step 2. Select [LOAD SETUP DEFAULT]

Select the “LOAD SETUP DEFAULT”menu and type “Y”at the prompt to load the BIOS optimal setup.

Step 3. Select [SOYO COMBO SETUP]

Move the cursor to the [CPU Frequency] field to set the CPU frequency.

Available [CPU Frequency] settings on your SY-V6BE+ Mainboard are detailed in the following table. If you set this field to [Manual], you are then required to fill in the next two consecutive fields: (1) the CPU Host/PCI Clock, and (2) the CPU Ratio.

Hardware

Installation

 

 

CPU Frequency

 

233MHz (66 x 3.5)

 

400MHz (100 x 4.0)

 

 

 

 

 

266MHz (66 x 4.0)

 

450MHz (100 x 4.5)

 

 

 

 

 

300MHz (66 x 4.5)

 

500MHz (100 x 5.0)

 

 

 

 

 

333MHz (66 x 5.0)

 

 

 

 

 

 

 

350MHz (100 x 3.5)

 

 

 

 

 

 

Select the working frequency of your Pentium® II processor among these preset values.

Note: Mark the checkbox that corresponds to the working frequency of your Pentium® II processor in case the CMOS configuration should be lost.

Note: if you use Bus Frequencies of 75 MHz, make sure that your PCI cards can cope with the higher PCI clock.

Step 4. Select [SAVE & EXIT SETUP]

Press <Enter> to save the new configuration to the CMOS memory, and continue the boot sequence.

11

Image 11
Contents Quick Start Guide SY-V6BE+ Serial Version 1.0 Edition November SY-V6BE+ MainboardUnpacking IntroductionSY-V6BE+ Mainboard Layout Preparations InstallationInstall the CPU Install the MainboardSpeaker Make Connections to the MainboardCPU Cooling Fan Cpufan KeylockRAM Type Set SW1 for power up FSB clock and AGP bus clockConfigure Memory Number of Memory ModulesClear Cmos Data JP5 Enable/Disable Power-On by Keyboard JP10SY-V6BE+Quick Start Guide Select Soyo Combo Setup Quick Bios SetupSelect Standard Cmos Setup Select Load Setup DefaultSoyo CD Start Up Program Menu Soyo CDInsert the Soyo CD into the CD-ROM drive Read Soyo model name ManualManual Selection Menu Install DriversPlease select your manual In the box below and click OK BackDriver Installation Menu Soyo CD Html Database in English Enter the Soyo CDSoyo Europe Edition November VersionInternational Headquarters USA Branch Office