Enable/Disable Power-On by Keyboard JP10

SY-V6BE+Quick Start Guide

Step 5. Set the CPU Frequency

This mainboard does not use any jumpers to set the CPU frequency, CPU setting are changed through the BIOS [SOYO COMBO SETUP]. Refer to Chapter 3 “Quick BIOS Setup”for details on how to set the Pentium® II processor frequency.

Step 6. Enable/Disable Power-On by Keyboard (JP10)

You can choose to enable the Power-On by Keyboard function by shorting pin 1-2 on jumper JP10, otherwise, short pin 2-3 to disable this function.

Power-On by

Keyboard

JP10 Setting

Enable

Short pin 1-2 to enable the

Power-On by Keyboard function.

1 2 3

Disable

Short pin 2-3 to disable the

Power-On by Keyboard function.

1 2 3

Important: When using the Power-On by Keyboard function, please make sure the ATX power supply can take at least take 720mA load on the 5V standby lead (5VSB) to meet the standard ATX specification. Apart from the jumper setting, you have to enter the CMOS setup and set the “Power-On by Keyboard” item in the SOYO COMBO Setup to “Password” or function key.

Step 7. Clear CMOS Data (JP5)

Clear the CMOS memory by momentarily shorting pin 2-3 on jumper JP5 for at least 5 seconds, and then by shorting pin 1-2 to retain new settings. This jumper can be easily identified by its white colored cap.

CMOS Clearing	Clear CMOS Data	Retain CMOS Data
	Short pin 2-3 for	Short pin 1-2
JP5 Setting	at least 5 seconds	to retain the
	to clear the CMOS. 1 2 3	new settings.	1 2 3

Note: You must unplug the ATX power cable from the ATX power connector when performing the CMOS Clear operation.

You MUST enter the CMOS SETUP and SAVE CMOS setting twice after clearing CMOS data. If you fail to do this your new setting would NOT be Saved.