SOYO SY-K7VLM-B quick start Cmos Clear JP5, ATX Power Supply ATX PW, Configure Memory

Hardware Installation

SY-K7VLM-BQuick Start Guide

ATX Power Supply: ATX PW

Attach the ATX Power cable to this connector. (This motherboard requires an ATX power supply, an AT power supply can NOT be used.)

When using the Power-On by PS/2 Keyboard function, please make sure the ATX power supply is able to provide at least 720mA on the 5V Standby lead (5VSB) in order to meet the standard ATX specifications.

Step 3. Configure Memory

Your board comes with two DIMM sockets, providing support for up to 1GB of main memory using unbuffered and registered DIMM modules from 32MB to 512MB. PC100/133 DIMM module is required on this motherboard.

Memory Configuration Table

Number of Memory Modules	DIMM 1	DIMM 2
RAM Type	SDRAM/ VCM SDRAM
Memory Module Size (MB)
	32/64/128/256/512 MB

CMOS Clear (JP5)

In some cases the CMOS memory may contain wrong data, follow the steps below to clear CMOS memory.

1.Clear the CMOS memory by momentarily shorting pin 2-3 on jumper JP5. This jumper can be easily identified by its white colored cap.

2.Then put the jumper back to 1-2 to allow writing of new data into the CMOS memory.

CMOS Clearing	Clear CMOS Data		Retain CMOS Data
	Short pin 2-3 for		Short pin 1-2 to
JP5 Setting	at least 5 seconds to		retain new settings
	clear the CMOS
	1 2	3	1 2	3

Note: You must unplug the ATX power cable from the ATX power connector when performing the CMOS Clear operation.

10