Cmos Clear JP5, Configure Memory

SY-7VCAQuick Start Guide

¡Note:° The STR LED is connected to the Voltage that feeds the DIMM sockets. Therefore the following table applies:

	Suspend to RAM	Normal Operation	Power Off
STR LED	ON	ON	OFF

Step 3. Configure Memory

Your board comes with three DIMM sockets, providing support for up to 1.5GB of main memory using unbuffered and registered DIMM modules from 8MB to 512MB. On this motherboard, DRAM speed can be set independent from the CPU front side bus speed. Depending on the DRAM clock speed setting in the BIOS setup, appropriate memory modules must be used. For 66MHz DRAM speed, use PC66 memory; for 100MHz DRAM speed, use PC100 memory; for 133MHz DRAM speed, use PC133 memory.

Memory Configuration Table

Hardware	Installation

Number of

Memory Modules

RAM Type

Memory Module

Size (MB)

DIMM 1		DIMM 2		DIMM 3

SDRAM / VCM SDRAM

8/16/32/64/128/256/512 MB

Note:Always install memory modules in the order prescribed in this table.

CMOS Clear (JP5)

In some cases the CMOS memory may contain wrong data, follow the steps below to clear CMOS memory.

1.Clear the CMOS memory by momentarily shorting pin 2-3 on jumper JP5. This jumper can be easily identified by its white colored cap.

2.Then put the jumper back to 1-2 to allow writing new of data into the CMOS memory.

CMOS Clearing

JP5 Setting

Clear CMOS Data

Short pin 2-3 for

at least 5 seconds to

clear the CMOS

1 2 3

Retain CMOS Data

Short pin 1-2 to

retain new settings

1 2 3

Note: You must unplug the ATX power cable from the ATX power connector when performing the CMOS Clear operation.