5.OPERATING THE KEYS
5.1In Run Mode
W= Enters the Program Menu
S= Displays the Maximum Value (if enabled). Press Sand hold while pressing RESETENTER to clear max. value.
T= Displays Minimum Value, if enabled. PressTand hold while pressing to clear min. value
RESETENTER = Resets Latched Relays (If any)
Sand T = Sets Zero/ICE Value (if enabled). Also clears Minimum and Maxi- mum Values
5.2In Program Mode
W= Enters the Edit Mode. Flashing cursor shows value to edit. (Numeric Val- ues only)
S = Scrolls “UP” through menu choices T = Scrolls “DOWN” through menu choices RESETENTER = Selects a menu or submenu to edit.
5.3In Edit Mode
W= Moves Edit Cursor to the left. Flashing cursor shows value to edit (Nu- meric Values Only)
S = Increases Numeric Value or Scrolls “UP” through
T= Decreases Numeric Value or Scrolls “DOWN” through
= Confirms and Saves your new setting.
IMPORTANT: After editing parameters, exit programming menu completely. If this step is not followed, changes will not be saved.
Page
2
Meas
OCTL
SCTL
PASS
ICE
ZERO
HILO
Anlg
FACt
rSEt
Entr
Pwrd
Cng
Pwrd
rst
Pwrd
On
Off
On
Off
Dir
SpAn
FS
Frd
Brd
Off
HI
LO
Full
rEAd
Value
Value
8 | 17 |