Driver Installation, Windows

5.Change JP1-JP2jumper settings to the desired voltage only if your serial device(s) needs additional power from the serial port. However, most serial devices do not require additional power. For more information, see Figure 1 on page 2. Skip this step if power is not required.

6.If you need the second serial port, connect the 9-pin ribbon cable connector now. See Figure 2 on page 3 for more details. Skip this step if you only need one serial port.

7.To install the card, carefully align the card's bus connector with the selected PCI slot on the motherboard. Push the board down firmly, but gently, until it is well seated.

8.Replace the slot bracket's holding screw to secure the card.

9.Replace the computer cover and reconnect the power cord.

Driver Installation

This section provides information on how to install the Cyber 2S1P PCI drivers.

Windows 95

1.At the Update Device Driver Wizard, click Next.

2.Insert the driver CD, and click Other Locations. Type in D:\9x, click OK, then Finish. (Change D: to match your CD-ROM drive letter)

3.From the Insert Disk window, click OK. When the Copying Files dialog box appears, type in D:\9x, then click OK.

4.Repeat steps 1-3.

5.Restart Windows to complete the installation.