For An Existing Installation
1.Install the board and boot up to Windows.
2.At the Add New Hardware Wizard, insert the driver CD.
3.Select Automatic search for a better driver (Recommended), then click Next.
4.Accept the default entry then click OK.
5.Click Finish.
6.Remove the driver CD, shutdown Windows, and setup your RAID array.
When Windows resumes, go to SATARaid GUI on page 17 and install the RAID monitoring utility.
To Verify Windows 98SE/ME Installation
1.Right click My Computer and click Properties. Select Device Manager tab.
2.Double click SCSI controllers, Silicon Image Sil 3512 SATARaid Controller should be displayed.
Windows2000
A new installation of Windows 2000 requires a floppy disk for the driver installation. To make this floppy disk, copy the contents of the Floppy folder, found on the driver CD, onto a blank floppy disk then follow the directions below.
For A New Installation
1.Setup the RAID array prior to Windows installation.
2.Follow Microsoft Windows 2000 installation procedure.
3.Restart the computer when prompted by the installation.
11