SIIG PCI-32T manual Hardware Installation, Board Layout

Board Layout

4-Pin Power

Connector

Firewire Port

(1394a)

Firewire 800

Ports

Figure 1. Board Layout

Hardware Installation

Note: For Low Profile systems, replace the currently mounted bracket with with the included Low Profile bracket.

General instructions for installing the card are provided below, since the design of computer cases and motherboards vary. Refer to your computer’s reference manual for further information, if needed.

Static Electricity Discharge may permanently damage your system. Discharge any static electricity build up in your body by touching your computer’s case for a few seconds. Avoid any contact with internal parts and handle cards only by their external edges.

•Turn OFF the power to your computer and any other connected peripheral devices. Unplug the computer's power cord.

•Remove your computer’s cover and install the card in an available PCI slot.

•Push the board down firmly, but gently, until it is well seated.

•Connect an available 4-pin power connector from the system power supply to the 4-pin power connector on the FireWire 800 PCI-32T(See figure 1). This connection is recommended for reliable power output.

•Secure the card and replace the cover.

2