Normal Removal &
Installation
A. Tubes |
|
B. Hair Pin Clip |
|
C. Bags |
|
D. Clevis Pin |
|
E. Cover |
|
F. Clip |
|
| E |
A | D |
| |
| B |
| C |
F |
|
Figure 9. Normal Removal & Installation
WARNING
OPERATION WITHOUT TURBO & CATCHER
For operation without turbo, the mower deflector MUST be properly installed in the down position and retained by the spring latch (See Turbo Operator’s Manual).
NORMAL REMOVAL & INSTALLATION
Removing the Grass Catcher
1.Disconnect the tubes (A, Figure 9) from the turbo and remove them from the catcher.
2.Remove the hair pin clip (B, Figure 9) and clevis pin
(D) securing the cover (E). Disconnect the cable (see Figure 8). Remove the cover (E).
3.Remove and empty the bags (C, Figure 9).
4.Warning: Back plate (A) will fall when rod (D) is removed. Remove the hair pin (B, Figure 10) and rod (D) while holding back plate (A).
5.Lift back plate & support assembly (A, Figure 10) off hitch plate (D)
A |
C |
B |
D |
Figure 10. Install Back Plate
A. | Back Plate & Support | C. Hitch Plate |
B. | Hair Pin | D. Rod |
14