Simplicity 1726793, 1694498 Removing and Reattaching Grass Catcher, Installing the Grass Carcher

Page 19

Removing and Reattaching Grass Catcher

Installing the Grass Carcher

1.Set the back plate & support (A, Figure 11) on pins of hitch plate (C). Secure with rod (D) and hair pin (B).

2.Install the bags (C, Figure 12).

3.Install the cover (E, Figure 12). Secure with the cle- vis pins (F) and hair pin clips (B).

NOTE: Push the hair pin clips all the way on or they will be bent by the hinge when the cover is opened.

4.Connect the cover cable (Figure 8).

5.Insert the tubes (A, Figure 12) into the catcher and connect to the turbo. Be sure the clip (F) is secured over the top of the turbo flange nut.

A

C

B

D

Figure 11. Install Back Plate

A.	Back Plate & Support	C. Hitch Plate
B.	Hair Pin	D. Rod

A. Tubes
B. Hair Pin Clip
C. Bags
D. Clevis Pin
E. Cover
F. Clip
	E
A	D
	D
	B
	C
F

Figure 12. Normal Removal & Installation

15

Image 19

Contents Should not be printed Paper Size * 11 xThis page Intentionally Blank Mfg. No. Description Clean Sweep Twin CatcherPage Table of Contents General Warnings Safety Rules InformationGeneral Operating Instructions Description 1784527 3427Install Deflector Hinge Assembly Install Discharge BaffleDeflector Removal Models Install DeflectorInstall Turbo Drive Pulley Install Idler Assembly & Belt CoverInstall Anchor Bracket Install Turbo Belt Install Belt Cover PlateInstall Mounting Bracket Install Turbo Drive Belt Install Turbo BlowerSecure Belt Cover Counter Balance & Weight Carrier Installation Initial Counter Balance & Weight Carrier InstallationInitial Hitch & Tube Installation Assemble Catcher Bags Assemble Tubes & DeflectorInstall Cover and Bags AssemblyInitial Collector Removing the Grass Catcher Normal Removal InstallationRemoving and Reattaching Grass Catcher Installing the Grass CarcherStandard Hardware Sizing Common Hardware TypesBolt or Nut