if ipmode = dhcp,
no parameters required if ipmode = pppoe,
par1 = PPPoE username, par2 = PPPoE password
>
Figure 2-11 Help screen example
Note:
The changed values will not take effect until ‘save’ and ‘reboot’ commands are invoked. For more details, please refer to section 2.4.5 ~ 2.4.7.
2.4.2 ‘get’ Command
With ‘get’ command, users can view the current parameter values and status of the LS100. Basic ‘get’ command usage is as follows:
get [group] + <CR> where,
group = 'ip','host','serial' , 'admin' or 'status'
-If group is specified, shows settings of the group.
-If group is omitted, shows settings of all groups.
The group means the category where parameters belong to as like ‘set’ command. For example, if users want to view parameter values related to IP configuration, get command as Figure
> get ip
IP_mode: static
IP_address: 192.168.1.100
Subnet_mask: 255.255.255.0
Gateway: 192.168.1.1
>
Figure 2-12 Getting ip configuration screen
‘status’ group is a special group where ‘set’ command does not apply. ‘get status’ will show current system status screen.
> get status
Serial_no.:
MAC_address:
F/W_REV.: V1.2.0
Current_IP: 192.168.0.125
>
Figure 2-13 Getting status screen
19