Senatek manual User Guide for the HelloDevice LS100

Page 2

User Guide for the HelloDevice LS100

Version 1.2.2

Firmware version 1.2.X

Last revised on November 8, 2005

Printed in Korea

Copyright

Copyright 2002, Sena Technologies, Inc. All rights reserved.

Sena Technologies reserves the right to make changes and improvements to its product without providing notice.

Trademark

HelloDevice™ is a trademark of Sena Technologies, Inc.

Windows® is a registered trademark of Microsoft Corporation.

Ethernet® is a registered trademark of XEROX Corporation.

Notice to Users

When a system failure may cause serious consequences, protecting life and property against such consequences with a backup system or safety device is essential. The user agrees that protection against consequences resulting from system failure is the user's responsibility.

This device is not approved for life-support or medical systems.

Changes or modifications to this device not explicitly approved by Sena Technologies will void the user's authority to operate this device.

Technical Support

Sena Technologies, Inc.

210Yangjae-dong, Seocho-gu Seoul 137-130, Korea

Tel: (+82-2) 573-5422

Fax: (+82-2) 573-7710

E-Mail:support@sena.com

Website: http://www.sena.com

2

Image 2

Contents

HelloDevice Lite Series LS100 User Guide User Guide for the HelloDevice LS100 Contents Page Introduction OverviewPackage Check List Product Specification Serial InterfaceTerminologies and Acronyms MAC addressAcronym Table Getting Started Panel LayoutPanel layout of the LS100 Connecting to the Network Connecting the HardwareConnecting the Power Connecting to the Device Connecting a network cable to the LS100Accessing Console Port Using Serial ConsoleData/Console switch of the LS100 Using Remote Console Telnet program set up exampleCommand Usage LS100 command set summary1 ‘set’ Command IP configuration example screen2 ‘get’ Command 11 Help screen example3 ‘help’ Command 14 Getting all parameters screen4 ‘factorydefault’ Command 15 Help screen7 ‘reboot’ Command 5 ‘save’ Command6 ‘exit’ Command IP Address Configuration IP configuration parametersOverview Static IP ConfigurationStatic IP Setting IP configuration parameters for Static IP mode DhcpPPPoE Dhcp ConfigurationPPPoE Configuration LS100 TCP/IP session modes Host Mode ConfigurationHost mode configuration parameters Listen TCP Server Mode Operations Sync-SentSync-Recvd Listen TCP Server Mode Configuration TCP server mode settingTCP Client Mode Operations Operations Serial data transferTCP Client Mode Configuration State Transition Diagram of TCP client modeTCP Server/Client Mode Operations TCP client mode settingTCP Server/Client Mode Configuration State Transition Diagram of TCP server/client modeTCP server/client mode setting Serial Port Configuration Serial Port Configuration parametersSet serial 9600 7 e 2 h s n Serial port configuration System Administration Administration parameters configurationSerial Port Pin Outs Appendix a ConnectionsEthernet Pin outs HelloDevice Ethernet Wiring DiagramSerial Wiring Diagram Appendix B Well-known Port Numbers Table B-1 Well-known port numbersSerial Console Troubleshooting Appendix C TroubleshootingPower/LED Status Troubleshooting Remote Console TroubleshootingTCP Server Mode Operation Troubleshooting IP Address TroubleshootingDhcp Troubleshooting Serial Communication Troubleshooting