EISA Fast SCSI Caching Adapter
nBELOW16.DSK is the memory allocator routine for buffer below 16 megabyte under NetWare V3.10. This file will be auto-loaded during installation. The similar function is default supported under NetWare V3.11.
3.1 ASPI drivers for NetWare
A). This sub-section explains major installation procedures for V4.00/4.01: After seeing a message block showing "Scanning for available drivers ..." during the installation, you'll find a list of default supported drivers.
Press <Ins> key to install the driver, NV40XBME.DSK, from drive A:. Press <F3> key to specify the path: >A:\NETWARE.40X. Select the NV40XBME.DSK and press the <Enter> for loading this driver.
Press another <Return> key to proceed the setting for I/O port address and IRQ.
B). This second sub-section introduces how to install driver modules, NV31XBME.DSK and ASPITRAN.DSK, and also the supports for both tape streamer and removable media devices. The ASPI driver installation procedures for V3.11/3.12/SFT-III and V3.10 are the same, except the command "load nv31xbme" is replaced by "load nv310bme" for NetWare V3.10. The following part of the section takes the NetWare V3.11 as the example for introduction.
Installing the DC-820B drivers
First copy the two files, NV311BME.DSK and ASPITRAN.DSK, from the NetWare driver diskette that comes with your DC-820B to the directory where the server program resides.
After booting up the NetWare operating system, load the DC-820B driver by typing at the prompt
:load nv311bme <Return>
ASPITRAN.DSK will be automatically loaded first, as shown on the console. The system then prompts you to select the I/O slot number of your DC-820B. If you forget this number, you can access it by entering the ECU. After
