CMS
CONTENTS
1INTRODUCTION
2UNPACKING
3PRODUCT FEATURE IDENTIFICATION
4ACCESSORIES
5INSTALLATION GUIDE
5.1MECHANICAL INSTALLATION GUIDE FOR SUSPENDED CEILINGS
5.2MECHANICAL INSTALLATION GUIDE FOR
5.3MECHANICAL INSTALLATION INSTRUCTIONS FOR OPTIONAL PLASTER RING
5.4INSTRUCTIONS FOR OPTIONAL
6WIRING AND SETTING UP
7DIMENSIONS
7.1CMS801 DC BM DIMENSIONS
7.2CMS801 DC PI DIMENSIONS
7.3CMS801 SUB BM DIMENSIONS
7.4CMS801 SUB PI DIMENSIONS
7.5CMS801 PI BACK CAN DIMENSIONS
8TECHNICAL SPECIFICATIONS
8.1CMS801 DC SPECIFICATIONS
8.2CMS801 SUB SPECIFICATIONS
9PAINTING
10WARRANTY
11DECLARATION OF CONFORMITY
1. INTRODUCTION
Thank you for purchasing this Tannoy Ceiling Monitor System product. This product range is suited for
2. UNPACKING
Every Tannoy product and accessory is carefully inspected before packing. After unpacking, please inspect your product to make sure no damage has occurred in transit. In the unlikely event of any damage, would you please notify your dealer immediately and retain your shipping carton, as your dealer may ask you to return the faulty unit to him for inspection.
Each CMS loudspeaker is packed in pairs and provided with the following accessories as standard; C Ring,
3. SAFETY NOTICES
Some regional construction codes require the use of a secondary method of securing loudspeakers in ceiling to provide security of a back up support. A secondary support line should be attached from the safety loop on the rear of the product to a source point on the ceiling. Please consult the relevant construction codes in your region.
When using a power driver to install the product it is essential to use the correct torque level settings to avoid over tightening and damage to the ceiling material or clamps.
Recommended torque setting: 1.5Nm
Tannoy will not be held responsible for any damages caused by the improper installation of these loudspeakers.
ELECTRICAL SAFTEY NOTICE:
To comply with the standard UL1480, metal - clad flexible conduit (BX) is required for connection to the terminal block for proper earth grounding.
In order to comply with UL regulations, the PI
SAFETY NOTE:
In order to comply with relevant fire safety regulations (i.e. BS 5839:1998), it is required that in the event of fire, that failure of the circuit to which the loudspeaker is connected does not occur before evacuation of the building is complete. Suitable measures include: -
a)use of terminal blocks (for connection to primary) with a melting point of not less than 650°C, for example constructed from ceramic materials;
c)use of terminal blocks of a lower melting point but protected with thermal insulation;
d)use of terminal blocks such that, on melting, an
2
3