Tannoy CMS801 sub PI Mechanical Installation Guide for Suspended Ceilings, Do not Overtighten

CMS	5.1 MECHANICAL INSTALLATION GUIDE FOR SUSPENDED CEILINGS
		1	Remove the ceiling tile from its frame and place it on a flat surface. Mark the
			cut-out area on the ceiling tile by tracing around the template provided.

2Cut out the hole in the ceiling tile using a circular saw or pad saw.

3	Place the C-ring and tile-bridge on top of the ceiling panel, aligning the C-ring over the
	hole, and screw the C-ring to the tile bridge using the fixings provided.

4	Slide the speaker assembly through the hole and turn the screws on the front of the
	speaker to extend the mounting wings. Tighten the screws until a firm grip is achieved.
	If using a power driver, Tannoy recommends a torque setting of 1.5Nm.
	DO NOT OVERTIGHTEN!

5	Slide the tile panel back into the suspended ceiling. The tile bridge ends will catch over
	the railings, supporting the weight of the speaker.

Go to section 6 for instructions on wiring and set-up instructions.

5.2 MECHANICAL INSTALLATION GUIDE FOR SHEET-ROCK (PLASTER BOARD) CEILINGS

1Mark the cut-out area on the ceiling by tracing around the template provided.

2	Cut out the hole in the ceiling using a circular saw or pad saw, then slide the
	C-ring into the ceiling, aligning it over the cut-out hole).

3Go to section 6 for wiring and set-up instructions then return to point 4 below.

4Slide the speaker assembly through the hole and turn the screws to extend the mounting wings. Tighten the screws until a firm grip is achieved.

If using a power driver, Tannoy recommends a torque setting of 1.5Nm.

DO NOT OVERTIGHTEN!

5Insert grille by pushing it onto the speaker.

6

7