Rotel RLC-1080 owner manual Limited Warranty, Replace Battery LED is illuminated

Page 13

Connected equipment reboots or turns off when the RLC-1080 switches to battery power.

Possible Cause: Battery was disconnected after unit was installed and powered on. Solution: If the battery is disconnected a warning appears in the VFD display. Remove the front bezel by grasping the sides and pulling straight back. Check the battery connection to make sure that it is firmly pushed into its battery connector socket.

Possible Cause: Unit is overloaded.

Solution: If too much equipment is plugged into the RLC-1080 the amount of time the system can be powered while running on battery power is very short. Using the front display, you can see how much of the UPS load capacity is used. See the section of this manual titled System Load: <XXXW; Load: <XXX%. Additionally, there is an Overload LED on the front panel which will light ‘red’ if the unit is overloaded. If the unit is near overload or overloaded (>95%), the load should be reduced by unplugging one or more components.

Possible Cause: Battery charge level was low at the time the RLC-1080 switched to bat- tery power.

Solution: Allow the RLC-1080 to fully recharge, by leaving the unit plugged in. It takes approxi- mately 8 hours to recharge a discharged battery to 90% capacity.

Possible Cause: If the above problem remains unsolved....

Solution: Contact Rotel Technical Support at 800-370-3741.

Replace Battery LED is illuminated.

Possible Cause: Battery is nearing the end of its useful life.

Solution: If it is more than two years from from the date of purchase, a Replacement Battery Car- tridge (part# RBC63) can be ordered from your au- thorized Rotel dealer or Rotel Technical Support at techsupport@rotel.com or 800-370-3741.

13

English

Limited Warranty

Rotel warrants this product to be free from defects in materials and workmanship for a period of two years from the date of purchase. Rotel’s obligation under this warranty is limited to repairing or replacing, at its own sole op- tion, any such defective products. To obtain service under warranty contact your authorized Rotel dealer or Rotel Technical Support at 800-370-3741.

If a product has to be returned for service you must include the following:

Prepaid transportation charges

Brief description of the problem encoun- tered

Proof of date and place of purchase

This warranty does not apply to equipment that has been damaged by accident, negligence, or misapplication or has been altered or modified in any way. This warranty applies only to the origi- nal purchaser who must have properly registered the product within 10 days of purchase.

EXCEPT AS PROVIDED HEREIN, ROTEL MAKES NO WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING WARRANTIES OF MERCHANT- ABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Some states do not permit limitation or exclusion of implied warranties; therefore, the aforesaid limitation(s) or exclusion(s) may not apply to the purchaser.

EXCEPT AS PROVIDED ABOVE, IN NO EVENT WILL ROTEL BE LIABLE FOR DIRECT, INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OF THIS PRODUCT, EVEN IF ADVISED OF THE POSSIBIL- ITY OF SUCH DAMAGE. Specifically Rotel is not liable for any costs, such as lost profits or revenue, loss of equipment, loss of use of equipment, loss of software, loss of data, costs of substitutes, claims by third parties, or otherwise.

Image 13
Contents RLC-1080 Important Safety Information Front and Rear Panel Controls and Connections About Rotel ContentsGetting Started Features Few PrecautionsParts List Power CapacityFront Panel Rear Panel System Test InstallationRack Mounting Information Screens Status ScreensStatus Screens EST. Runtime Xhrs ScreenSensitivity Setting Audible Alarm SettingModel Number Serial Number Screen Internet Address ScreenLED Dimmer Setting Display Dimmer SettingGO to Battery if Xxxv Setting Outlet DELAY1 Outlet DELAY2 SettingTroubleshooting Replace Battery LED is illuminated Limited WarrantyInput SpecificationsPage USA