Status Screens, Information Screens

SELFTEST IS ON; ON-LINE SELFTEST screen shows that an On-Line Selftest is ac-

tive.

��

SELFTEST IS ON; ON-BATTERY SELF-TEST screen shows that an On-Battery Selftest is active with the unit internally switched to power from the internal battery pack, which should already be connected within the unit. The On Battery LED is also lit during this test.

��

The unit will also test to see if an optional exter- nal battery pack is connected to the unit. If no external battery pack is connected to the unit

NO EXTERNAL BATTERY CONNECTED

will be displayed.

��

SELFTEST RESULT; SELFTEST HAS PASSED screen shows that the Selftest ran successfully to completion. If the message TEST HAS FAILED is displayed, please contact APC Technical Support.

��

Status Screens

The most important status screens available after the Selftest has completed are:

•Input Voltage: XXXV;

Output Voltage: XXXV

•System Load: <XXXW; Load: <XXX%

•Estimated Runtime: XHrs; Fuel: XXX%

INPUT VOLTAGE: XXXV

OUTPUT VOLTAGE: XXXV

This screen shows the input voltage from the wall power outlet and the voltage being supplied to the connected devices.

��

Note: As the screen above shows, at times, the voltage values on this screen may not match. This may be due to the fact that separate circuits are used to make these voltage measurements, and there is a time delay between the two circuits for updating this status screen. This condition is normal. Also, the voltage values may not match if the AVR is active.

SYSTEM LOAD: <XXXW

LOAD: <XXX%

This screen shows the power load of the connected equipment in watts, as well as a percentage of the total allowable load connected to the unit. Loads less than 5% of the rated power (50 watts) are displayed as < 5%.

��

EST. RUNTIME: XHRS

FUEL: XXX%

This screen shows the Estimated Runtime (in hours), as well as the Fuel capacity of the internal battery pack (as a percentage) based on the total load connected to the device. If the Estimated Runtime is less than one hour it is shown in minutes.

English

Information Screens

Another group of screens provide information about the RLC-1080. These screens are accessed by using the STATUS push button:

•Source: XXXXXXX screen

•FW Version: XXXXXXX screen

•Model Number and Serial Number screen

•Internet Address screen

•Input Frequency; Output Frequency screen

SOURCE: XXXXXXX

EST. RUNTIME: XHRS Screen

This screen shows the power source the unit is using to provide power (UTILITY or BATTERY) or if it is in STANDBY mode. It also displays the Estimated Runtime (in hours) based on the power source and connected equipment load. In Standby mode, the unit does not provide an output to the rear panel outlets.

Note: Whenever the RLC-1080 is connected to a “live” wall power outlet, the electronics inside are active. If the front panel Power Switch is turned off, the unit goes into Standby mode and shuts off power to the rear-panel outlets, but the display remains active.

��

Firmware Version: XXXXXXX Screen

This screen provides information about which version of the ﬁrmware is loaded in to the unit. Please have this information available any time you need to talk with Rotel Technical Support.

��