Using Wireless Headphones

Rosen M10 Owner’s Manual

REPLACING HEADPHONE BATTERIES

The system is compatible with wireless infrared (IR) single-channel headphones (AC3003). These headphones receive a signal from an IR transmitter built into the M10. These headphones allow rear-seat passengers to listen without using the vehicle speakers.

To turn the headphones on and off, push the Power ON/OFF button on the right ear piece. The Power LED on the left ear piece indicates when headphone power is on. Power turns off automatically after three minutes of no audio, in order to preserve battery life.

Adjust headphones

The wireless IR headphones require two AAA batteries. To replace the batteries, slide off the battery compartment door on the right earpiece and insert batteries, as shown. Make certain that the battery orientation matches the marks inside the battery compartment.

To adjust the headphone volume, rotate the thumb wheel on the headphones.

here

To adjust the headphone size for differently-sized heads,

slide the top as needed.

Power ON/Off switch

Volume Knob

Power LED

The M10 IR transmitter has two output channels, A and B. Using A and B, the M10 can transmit two different audio programs at the same time. When using optional Rosen AC3072 dual-channel headphones, listeners can switch between Channels A and B. For more, see P. 19.

When the M10 is installed as a second display for a Rosen A10 system, the A10 is the infrared transmitter for both Channels A and B, and the M10 infrared transmitter is disabled.

USING OPTIONAL WIRED HEADPHONES

There is a jack for wired headphones on the forward edge of the unit, under a removable cover. When using optional wired head- phones, only use headphones with a volume control, since the system has no volume adjustment.

Mini-stereo Headphone Jack