Faq’S

Rosen M10 Owner’s Manual

I HAVE NO PICTURE AND NO SOUND - WHAT’S WRONG?

The system has low- and high-voltage and temperature protection

circuits. If the voltage or temperature goes beyond the limits, the system shuts off. The power wire or power harness may have been disconnected, or the fuse may have failed. Contact your Rosen authorized dealer to determine if this is the case.

Note: The system voltage range is 11-16VDC operating voltage. The system operating temperature is 0o to 60o Celsius. Use of the system beyond the safe operating ranges listed can cause temporary or permanent damage to the unit - such damage may not be covered by manufacturer’s warranty.

WHY DO I GET NO RESPONSE WHEN I PRESS THE REMOTE BUTTONS?

Check the battery in the remote control. Remember that the source-unit functions are conly compatible with certain Rosen-brand source units. If the M10 is installed as a second screen for a Rosen A10, the M10 will not respond to its remote, but its remote will control the A10.

I HAVE BLACK BARS ON THE TOP AND BOTTOM OF MY SCREEN WITH A WIDESCREEN DVD - HOW DO I GET RID OF THEM?

See page 17.

WITH THE AC3072 DUAL-CHANNEL HEADPHONES, CHANNEL A AND CHANNEL B HAVE THE SAME AUDIO. HOW DO I CHANGE WHAT I HEAR ON CHANNEL B?

I HAVE A PICTURE, BUT NO SOUND OR DISTORTED SOUND. WHY?

Check the MUTE button. Check the volume on the radio, and make sure the radio is tuned to the right frequency - try tuning the FMM and the radio to a new frequency. Check the headphones; ensure the headphones have a direct “line of sight” to the infrared transmitter below the monitor. Replace headphone batteries, if needed. Check the DVD Setup Menu - the Audio Output setting must be set to “ANALOG” and the Speaker Downmix setting must be set to “STEREO”. If using a CD you have made yourself, make sure you did not set the recording level too high. Make sure you to check CH A and CH B if you are using AC3072 two-channel headphones.

THE DOME LIGHT WENT OUT - WHY?

The dome light has a 5-minute timer to prevent accidental battery drain.

Press OUTPUT B and then press SOURCE to change Output B’s assigned source. See page 19 for more information on dual-zone use

I have no audio on Channel or Channel B of the wireless headphones.

Check the batteries. Check the Mute button. If the M10 is installed as the ssecond screen of a Rosen A10 system, the A10 is the only IR headphone transmitter, and the M10 IR headphone transmitter is

disabled.

If this section does not address your question, please contact your Rosen authorized dealer. Also, your system has internal diagnostic capabilities that are accessible to authorized Rosen dealers. To locate a Rosen Entertainment Systems authorized dealer, please visit