Verbatim External Hard Drive NAS manual Rear Panel Area

Rear Panel Area

Along the rear panel you will find the interface connectors and a recessed micro-switch that is used for reset functions. Refer to the figure below.

1 2 3 4 5

1. Reset Button. If the NAS drive is having a problem connecting to the local area network (LAN) or appears to be hung, press the Reset button momentarily with the end of a paper clip. This will cause the unit to reset, similar to rebooting your PC. If the problem persists, or if you are unsure of current settings (such as forgetting your administration password), press and hold in the Reset button for 5 seconds. This will restore the factory default settings.

2.DC Input Connector. Connect the DC cable of your included AC Adapter to the DC Input Connector.

3. USB-A Connector. Use this connector for attaching a USB printer, USB flash disk, or other USB storage device.

4. USB-B Connector. Use this connector to attach the NAS drive to your computer via USB. Refer to “Which Interface: USB or Ethernet” later in this manual.

5.Ethernet Connector. If you plan to use the Ethernet interface to connect to a LAN, then use this connector to attach to your network equipment. Refer to “Which Interface: USB or Ethernet” later in this manual.

7