Verbatim K7VT4-8X Installation of Memory Modules Dimm, Expansion Slots PCI and AGP Slots

Page 12

2.5 Installation of Memory Modules (DIMM)

K7VT4-4X / K7VT4-8X motherboard provides two 184-pin DDR (Double Data Rate) DIMM slots.

Please make sure to disconnect power supply before adding or removing DIMMs or the system components.

Step 1. Unlock a DIMM slot by pressing the retaining clips outward.

Step 2. Align a DIMM on the slot such that the notch on the DIMM matches the break on the slot.

Step 3. Firmly insert the DIMM into the slot until the retaining clip snap back in place and the DIMM is properly seated.

2.6 Expansion Slots (PCI and AGP Slots)

There are 5 PCI slots and 1 AGP slot on K7VT4-4X / K7VT4-8X motherboard. PCI slots: PCI slots are used to install expansion cards that have the 32-bit PCI

interface.

AGP slot: The AGP slot is used to install a graphics card. The ASRock AGP slot has a special locking mechanism which can securely fasten the graphics card inserted.

Please do NOT insert a 3.3V AGP card into the AGP slot of

K7VT4-4X or K7VT4-8X motherboard!

It may cause permanent damage!

Installing an expansion card

Step 1. Before installing the expansion card, read the documentation of the expansion card and make necessary hardware settings for the card.

Step 2. Remove the system unit cover (if your motherboard is already installed in a chassis).

Step 3. Remove the bracket facing the slot that you intend to use. Keep the screw for later use.

Step 4. Align the card connector with the slot and press firmly until the card is completely seated on the slot.

Step 5. Fasten the card to the chassis with screws.

Step 6. Replace the system cover.

1 2

Image 12
Contents K7VT4-4X K7VT4-8X Copyright Notice DisclaimerContents Package Contents IntroductionSpecifications CPUIDE LANPage Motherboard Layout K7VT4-4X Motherboard Layout K7VT4-8X ASRock I/OTM K7VT4-4X / K7VT4-8X Installation Pre-installation PrecautionsScrew Holes CPU Installation Installation of CPU Fan and HeatsinkInstallation of Memory Modules Dimm Installing an expansion cardExpansion Slots PCI and AGP Slots Jumpers Setup PS2USBPWR1FID Jumpers CLRCMOS1 CLRCMOS2 Connectors IDE2Front panel audio connector 9-pin AUDIO1 See p.7/p.8 item Bios Setup Bios Setup UtilityBios Menu Bar Main Menu ESCType AutoAdvanced, Security, Power, Boot, and Exit Menus Software Support Appendix Advanced Bios Setup Advanced Bios Setup MenuChipset Configuration Resource Configuration RPM Security Setup Menu EnterPower Setup Menu Boot Setup Menu Exit Menu