Verbatim K7VT4-4X, K7VT4-8X user manual Jumpers Setup, PS2USBPWR1

2.7 Jumpers Setup

The illustration shows how jumpers are setup. When the jumper cap is placed on pins, the jumper is “SHORT”. If no jumper cap is placed on the pins, the jumper is “OPEN”. The illustration shows a 3-pin jumper whose pin1 and pin2 are “SHORT” when jumper cap is placed on these 2 pins.

Jumper	Setting
FSB_SEL0	1_2		2_3
(see p.7/p.8 item 10) FSB_SEL0		FSB_SEL0	FSB_SEL0
	FSB 200MHz	FSB 266MHz	FSB 333MHz

Note: The setting of the CPU front side bus frequency of this motherboard is by means of the adjustment of jumper-setting. Please follow the figures above to set the CPU front side bus frequency.

PS2_USB_PWR1	1_2	2_3	Short pin2, pin3 to enable
(see p.7/p.8 item 1)	+5V	+5VSB	+5VSB (standby) for PS/2 or

USB wake up events.

Note: To select +5VSB, it requires 2 Amp and higher standby current provided by

power supply.

JR1(see p.7/p.8 item 26)	JR1	JR1
JL1(see p.7/p.8 item 25)	JL1	JL1
	fig. 1	fig. 2

Note: When you connect speakers in back panel and front panel at the same time,

1.If the jumpers JL1 and JR1 are short (see fig. 1), both front panel and rear panel audio connectors can work.

2.If both jumper caps on JL1 and JR1 are removed (see fig. 2), only front panel audio works.

However, it requires your front panel to support the function.

1 3