Unitech MP300 manual Loading Supplies, Adding Paper, Tearing Paper

Page 8

Chapter 2

Loading Supplies

Adding Paper

The printer can print text, bar codes and graphics on thermal receipt paper. See “Supply Specifications” on page 32 for the width, thickness requirements and approved vendors. Follow these steps to load printer paper:

Open the paper supply cover by placing your fingers under the “T” pull lever. Pull up firmly on the supply cover until the lever stops moving.

Please be careful not to force the “T” pull lever too far back.

Place the paper roll into the paper supply well. Make sure the paper supply unwinds from the bottom as shown below.

Position the paper supply between the print-head guides.

Make sure some supply (2” - 3”) extends beyond the top of the paper supply well.

Shut the paper supply cover and press close.

NOTE: To prevent any possible damage to the print-head mechanism, it is important to verify that the paper has not been fastened to the inside core in any way. The paper should be wound on the core in such a way that the end of the paper will unwind freely from the core. If fastened by tape or glue, the core will be pulled into the mechanism causing jamming and possible gear damage.

Copyright 2008 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.

14

Tearing Paper

The printer’s paper door acts as a tear bar. Pull one edge of the paper against the tear bar as indicated, then pull down and across against the tear bar to rip the paper.

NOTE: Using the tear bar is the only way to rip the paper. Pulling up and sideways without using the tear bar can cause a paper jam due to paper misalignment in the print-head mechanism.

Copyright 2008 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.

15

Image 8
Contents MP300 Mobile Printer About This Manual SupportTable of Contents What’s in the Box Getting StartedIntroducing the MP300 Communication Options Tour of the MP300Declaration of Conformity Installing and Charging the Battery Installing the BatteryCharging the Battery Battery NoticesAttaching the Belt Clip LED Indicator State StatusReading the LED Status Tearing Paper Loading SuppliesAdding Paper Using the Printer Initial Power Up and Self-TestConnecting the Printer DIP Switch LocationSerial Communication Specification Setting DIP Switches DIP Switch FunctionsRJ45 Connector Pin # CommunicationMagnetic Stripe Reader Option Infrared Communication Mode IrDABluetooth Communication Option Printer Font Commands Courier Character Set Printer Font CommandsProgramming Information Ascii Control CharactersMagnetic Stripe Reader Commands When MSR is Installed Smart Card Reader Control Commands when SCR is installedGraphic Logo and Bar Code Commands Printer Supervisory and Control CommandsPrinter Maintenance Print-Head CleaningCharging the Printer Battery Verifying Battery Charge StateTrouble Shooting To Test the DC PowerTo Test if the Battery is Accepting the Charge Battery and Safety InformationSpecifications Printer SpecificationsPrinter Supplies Part Number DescriptionRegulatory Notes and Warranty Supply SpecificationsWarranty FCC Part 15 Class BWarranty and/or Repair Service