Unitech MP300 manual Using the Printer, Initial Power Up and Self-Test, Connecting the Printer

Page 9

Chapter 3

Using the Printer

Initial Power Up and Self-Test

Once the battery is charged and the paper is loaded, an initial power up and self-test can be performed.

Press the on/off button once. This powers on the printer. LED 1 illuminates in green or blue depending on the communication mode.

The printer will remain on until it is manually powered off.

Press the on/off button to power the printer off. The LED turns off.

To start the self-test, press and hold the feed button then press the on/off button.

The printer will start printing the self-test messages. Release the feed button.

Press the on/off or feed button to stop or cancel the self-test print.

The first few lines of the self-test show the printer firmware version,

the current printer settings (for example IrDA or Serial mode) and a list of any optional or special features installed.

Copyright 2008 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.

16

Connecting the Printer

The MP300 supports Serial RS232 and IrDA compatible infrared

communication interfaces. Radio frequency (RF) Bluetooth communication is also available as an optional feature.

Serial, IrDA and Bluetooth communication settings can be changed via a

DIP Switch located on the control card.

Printer drivers for Windows 95/98/NT/2000/XP/Vista are available from

Unitech.

PrinterCE print control utility for Windows CE devices is available from Unitech.

Printboy Print Utility from Bachmann Software or PalmPrint Utility from

StevensCreek are recommended for mobile computer devices.

DIP Switch Location

The DIP Switch is located inside the battery compartment. The DIP Switch location is shown below.

The functions assigned to these switches are on page 18.

If the serial interface is selected, the communication parameters; baud rate, data bit and parity must be set. These parameters apply both for UART 1 and UART 2.

DIP Switches

Copyright 2008 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.

17

Image 9
Contents MP300 Mobile Printer Support About This ManualTable of Contents Getting Started Introducing the MP300What’s in the Box Tour of the MP300 Declaration of ConformityCommunication Options Installing the Battery Installing and Charging the BatteryCharging the Battery Battery NoticesLED Indicator State Status Reading the LED StatusAttaching the Belt Clip Loading Supplies Adding PaperTearing Paper Initial Power Up and Self-Test Using the PrinterConnecting the Printer DIP Switch LocationSetting DIP Switches DIP Switch Functions Serial Communication SpecificationRJ45 Connector Pin # CommunicationInfrared Communication Mode IrDA Bluetooth Communication OptionMagnetic Stripe Reader Option Printer Font Commands Printer Font Commands Courier Character SetProgramming Information Ascii Control CharactersSmart Card Reader Control Commands when SCR is installed Magnetic Stripe Reader Commands When MSR is InstalledGraphic Logo and Bar Code Commands Printer Supervisory and Control CommandsPrint-Head Cleaning Printer MaintenanceCharging the Printer Battery Verifying Battery Charge StateTo Test the DC Power Trouble ShootingTo Test if the Battery is Accepting the Charge Battery and Safety InformationPrinter Specifications SpecificationsPrinter Supplies Part Number DescriptionSupply Specifications Regulatory Notes and WarrantyWarranty FCC Part 15 Class BWarranty and/or Repair Service