Uniden UBC-RH96 manual Operation, Version

Page 16

Operation

Apply power to your target scanner and set its Baud Rate to the highest setting. Make sure that the Remote Control cable is properly connected, and rotate the VOL control clockwise past OFF until it clicks.

The LCD displays the following screens (your version number may be different than the screen shown here):

If you have not connected a target scanner, you see the screen below. If the UBC-RH96 remains on while you turn on the scanner, this display is automatically replaced with the scanner’s initial display.

UBC-RH96

Scanner

Unconnected

UBC-RH96

Press MENU Key for Config.

Uniden Bearcat UBC-RH96

Version 1.00.00

16

UBC-RH96 Digital Scanner OM.indd16 16

10/9/07 4:16:02 PM

Image 16

Contents UBC-RH96 UBC-RH96 Digital Scanner OM.indd2 10/9/07 41556 PM Table of Contents Speciﬁcations One Year Limited Warranty Introduction Included with your UBC-RH96 Using the Mounting Bracket Mounting the UBC-RH96UBC-RH96 Using Hook and Loop Material DC Power Input Jack UBC-RH96 ConnectionsRemote Head and Scanner Power Connecting CablesControl Cable Data Port Cable Firmware Updates Control Conﬁguration Guides UBCD396T Key Conﬁguration UBCD996T Key Conﬁguration Operation VersionSetting the UBC-RH96 Backlight Powering down the remote head does not turn off the ScannerConﬁguration Menu Mode Setting the UBC-RH96 LCD ContrastSetting Mobile Options Mobile Default Key AssigmentFunc +MENU Setting Handy Options Default Handy Option Key AssigmentSetting the Function Mode Setting Hold TimerVolume Settings For Handy Scanner Setting Auto ReleaseMiscellaneous Serial Operation Precautions Control LimitationsInitialize Memory Reset ONE Year Limited Warranty SpeciﬁcationsParts Covered 2007