Uniden UBC-RH96 manual Initialize Memory Reset

Page 25
#NN/GOQT[%NGCT
2NGCUG9CKV

Initialize Memory (Reset)

To reset the UBC-RH96 to factory default settings, follow the sequence below. Note that once done, there is no undo and all programmed keys are reset.

With the unit off, press and hold the following keys and turn on power at the same time: [2], [9] and [HOLD].You see the reset screen below.

If you turn off power during reset, the process starts again when you next turn on the unit.

Using the Cable Clamp A self-adhesive clamp/ guide is provided to

assist you to safely route the Remote Cable

to your target scanner. Clean the planned location, peel the base

covering, and firmly press it on the scanner.

Then route the Remote Cable through the guide. This helps assure that the remote Cable will not come out of the special connector on either a Mobile of Handy scanner.

25

UBC-RH96 Digital Scanner OM.indd25 25

10/9/07 4:16:04 PM

Page 24 Page 26
Image 25
Page 24 Page 26
Contents UBC-RH96 UBC-RH96 Digital Scanner OM.indd2 10/9/07 41556 PM Table of Contents Specifications One Year Limited Warranty Introduction Included with your UBC-RH96 Mounting the UBC-RH96 Using the Mounting BracketUBC-RH96 Using Hook and Loop Material UBC-RH96 Connections DC Power Input JackRemote Head and Scanner Power Connecting CablesControl Cable Data Port Cable Firmware Updates Control Configuration Guides UBCD396T Key Configuration UBCD996T Key Configuration Version OperationPowering down the remote head does not turn off the Scanner Setting the UBC-RH96 BacklightSetting the UBC-RH96 LCD Contrast Configuration Menu ModeMobile Default Key Assigment Setting Mobile OptionsFunc +MENU Default Handy Option Key Assigment Setting Handy OptionsSetting Hold Timer Setting the Function ModeVolume Settings For Handy Scanner Setting Auto ReleaseMiscellaneous Control Limitations Serial Operation PrecautionsInitialize Memory Reset Specifications ONE Year Limited WarrantyParts Covered 2007
Top Page Image Contents