Uniden DSS 2455, DSS2465 Placing a Call on Hold, Redialing a Call, Redialing from Standby Mode

Page 30

UP308BH (DSS2465) ENG OM 1/14/05 11:46 AM Page 24

PLACING A CALL ON HOLD

1)During a call, press (or on the base).

Once 10 seconds has passed or when you press , the call will be put on hold.

2)To talk to the caller, press or on

a handset (or (talk) on the base). The phone will return back to the call.

You can hold a call for 5 minutes, when 5 minutes has passed, the call is disconnected and the phone returns to the standby mode.

H o l d , t o t r a n s f e r

H a n d s e t

# 2

 

 

 

 

 

H a n d s e t

# 3

 

 

 

 

 

BACK

BACK

 

 

OK

L i n e

O n

H o l d

H a n d s e t

# 1

 

 

 

N e w :

1

 

 

 

 

 

MENU

 

 

CID RDL PB

 

 

 

 

 

• If you press

,

the operation

 

REDIALING A CALL

< R e d i a l 1 >

The last three phone numbers dialed can be0 2 9 5 9 7 9 0 3 5 quickly redialed.

is canceled.

• When the telephone is

automatically redialing

a number, the speaker

function is disabled

for a few seconds.

[ 24 ]

Redialing from Standby Mode

1)Press the CID RDL PB soft key in the standby mode.

2)Press / ▲ or ▼ to select “Redial History”, then press the OK soft key. The phone number that was last dialed appears in the display.

3)Press / ▲ or ▼ to toggle through the last three phone numbers dialed.

4)Press or . The selected number is dialed.

5)To hang up, press .

BACKDELETE

or

<R e d i a l 2 > 5 4 5 2 9 3 0

BACKDELETE

or

<R e d i a l 3 > 6 5 6 7 9 8 3

BACKDELETE

Page 29 Page 31
Image 30
Page 29 Page 31
Contents Guide Installation & Safety ChooseQuick Start Guide Your phone installed and operating as quickly asAdvanced features of the DSS2455 DSS2465 seriesConnecting the charger DSS2465 only AA batteries below to install the batteriesCharging the handset Contents Getting Started Controls and FunctionsMicrophone Key DC Power Input DSS2465 only Talk Key/speaker LEDDelete Key Answer on Key Record Key Charge LED DSS2465 onlyUniden Company Philosophy WelcomeFeatures Checking the Package Contents TerminologyMounting the Base Unit on a Wall Battery MaintenanceBattery use time per charge Refer to through 6 to mount the baseCleaning the battery charging contacts Installing the BeltclipLow battery alert Battery replacement and handlingHeadset Installation Display and IconsN 1 2 0 0 a N 1 N d s e t Standby modeAbout Soft KEY Function L k 3 4 8 9DSS2455/DSS2465 Flow Chart From the standby modeDirectLink soft key From the Talk mode Handset Setup About the MenuSummary of the Main Menu and Submenu Answering Setup Auto TalkGlobal Setup System ResetEntering the Menu Setting UP the MenuPress the Menu soft key in the standby mode N 1DirectLink Mode Handset SetupSetting a Ringer Volume Distinctive Ringer Setup Setting the Auto TalkSelecting a Ringer Tone Setting the Anykey Answer Setting the BannerAdjusting the LCD Contrast Setting the Ring Time Answering System SetupSetting a PIN Code Setting the Record TimeSetting the Message Alert On or Off Setting the Call ScreenSetting the Answer Mode Setting Insert Zero New Zealand only Global SetupSetting Name Tag POP ID Setting Day and TimeSystem Reset Deregister the Base SettingDeregister the Handset Making and Receiving Calls From the Handset From the BaseRedialing from Standby Mode Placing a Call on HoldRedialing a Call Deleting a Redial Record Redialing from Talk ModeRedialing from the Base L e t e R e d i a l 1 ?L k Adjusting the Earpiece and Handset Speaker VolumeClarity Booster O s t e r C o r d i n g L l e rWith the handset Mute MicrophoneTraveling OUT-OF-RANGE With the base9 5 6 7 9 0 3 Flash and Call WaitingNEW Message LED If the call waiting tone sounds during a callPhonebook S t i n c t i v e R i n g N o S e l e c t n I c k e r O r e / E d i t N a m e M o v i e sO r e / E d i t N o 0 7 3 0 3 4 5 E e d A l S e l e c t n D 1 E m p t ySteps for Entering Names and Special Characters Number of times key is pressedIf you make a mistake while entering a name Use or to move the cursor to the incorrect characterA r c h O r e S T O R E Viewing the PhonebookO n e b o o k A r c h a ZFrom Talk Mode Making Calls Using the PhonebookFrom Standby Mode Speed DialingL e t e M e m o r y ? O n e b o o k A r c h a Z O r e S T O R EO r e / E d i t N a m e Editing the Stored DataDeleting the Stored Data Chain DialingStoring Phone Numbers Making Calls with Memory DialingN e I t h You must subscribe to Caller ID service to use this featureCaller ID DateViewing the Caller ID List L e t e C a l l e r I D Y e s Deleting a Caller ID messageDeleting all Caller ID names/numbers L l e r T a lAdding Zero to Caller ID message New Zealand only Using the Caller ID Message ListCalling a party from the Caller ID list Storing Caller ID messages in the PhonebookDigital Tapeless Recording FeaturesIntegrated Answering Device Call Screening On/Off Selectable Outgoing MessagesTurning the Answering System ON/OFF Setting UP Your Answering SystemSetting your outgoing message Greeting Pre-recorded messageSetting the base ringer volume Choosing between the two outgoing messagesDeleting an outgoing message Adjusting the speaker volume level Using the menu modeSetting the Time Setting a PIN codePress to select the hour Setting the ring time Selecting the message record timeAnnounce only feature Setting the message alertTurning the message alert tone Off by pressing any key Setting the call screen Screening a callUsing Your Answering System Playing your messagesRepeating a message Skipping a message Deleting a messageAgain after From the handset Voice memoRecording a conversation From the baseRemote access away from home Remote OperationRemote access with the handset Command FunctionPlaying incoming messages Connecting the Charger Expanding Your PhoneBatteries Register the Handset To enter the DirectLink mode e See DirectLink callWhen speaking on the handset When speaking on the baseWAY Conferencing From handset to handset or to the base INTERCOM/CALL Transfer FeatureIntercom I n t e r c o mTo handset or to the base in the intercom section Call Transfer FeatureDuring a call, press On the handset Call will automatically be placed on hold, and anChanging the Digital Security Code Battery replacement and handling Troubleshooting Symptom SuggestionOnly 4 handsets can be registered to the base If more than 3 handsets are in use, you may not be able toFluorescent lights, and electrical appliances Make sure that you have registered all handsetsHandset or the base can’t Or Setting the Time onIf you still have a problem Join the conversation For the conference are not in useIndex K, LRemote access away from home Remote Operation CardTask Warranty One Year Limited WarrantyExpand Your System
Related manuals
Manual 76 pages 59.12 Kb

DSS2465, DSS 2455 specifications

The Uniden DSS 2455 and DSS 2465 are advanced digital cordless phones designed for enhanced communication and convenience. These models are packed with features that cater to the needs of modern households and businesses, providing high-quality sound, exceptional range, and user-friendly functionality.

One of the standout features of both the DSS 2455 and DSS 2465 is their digital spread spectrum technology. This technology not only ensures clearer conversations by minimizing interference but also enhances security by encrypting calls, making it difficult for eavesdroppers to tap into conversations. The range of these cordless phones is also impressive, allowing users to move throughout their homes or offices without losing signal quality.

Another key characteristic of these models is their multi-handset capability. The DSS 2455 and DSS 2465 can support multiple handsets, allowing users to extend their calling capabilities throughout larger spaces. This makes it easy for families or teams to stay connected without needing to be in close proximity to a single base unit.

The phones also come equipped with an alluring array of features that enhance their usability. Both models boast a large, backlit LCD display, making it easy to see caller information and navigate through the phone book and menu options, even in low-light conditions. Alongside a built-in answering machine, users can enjoy the convenience of receiving messages while away from home.

In terms of battery performance, the DSS 2455 and DSS 2465 utilize rechargeable lithium-ion batteries that offer considerable talk time and standby durations. These phones also incorporate power-saving features that help optimize battery usage, ensuring that users can rely on their devices without frequent recharging.

Moreover, the caller ID function is a valuable feature for identifying incoming calls, allowing users to manage their communications better. The ability to store a large number of contacts ensures that important numbers are easily accessible.

In summary, the Uniden DSS 2455 and DSS 2465 represent a blend of modern communication technology, practicality, and user-friendly design. With their advanced features, reliable performance, and stylish appearance, these cordless phones are ideal for those seeking a sophisticated and efficient communication solution in both home and office environments.
Top Page Image Contents