5.Apply a 1/8" thick layer of sealant around the lip of the plastic or bronze housing. A thin layer should also be applied up the sidewalls to a height of 1/4" greater than the hull thickness. This will ensure there is sealant material in the threads to seal them, and hold the housing nut securely in place.
6.From the outside of the hull, push the housing (with sealant applied) into the drilled hole. Apply a twisting motion to the housing to squeeze out excess sealant.
GASKET
(OR RUBBER) HULL
SEALANT
7.Put the nut on the transducer from the inside of the hull. If nylon, hand tighten only.
8.Clean off any excess sealant from around the transducer.
STEM-TYPE (POWER BOAT BRONZE) TRANSDUCERS
The
10