1.Connect the main unit to a
2.Connect the BLACK wire to the negative
3.Connect the RED wire to the positive (+) battery terminal.
4.Make sure the connections are clean and tight so they do not vibrate loose during the boat’s operation. Occasionally clean any accumulated corrosion from the battery terminals.
5.If for some reason the fuse is blown, replace with a 1 amp fuse, normal blow.
DO NOT OVER FUSE! The unit consumes 0.25 amps of current when it is on. You will want to keep your battery fully charged.
INSTALLING THE TRANSDUCER
The three most popular transducer styles are:
∙TRANSOM MOUNT – Ideal on boats with outboard engines, or on I/O driven boats.
∙
∙
TRANSOM MOUNT TRANSDUCERS
Selecting An Installation Location
Mount the transducer fairly close to the centerline (keel) of the boat, which will ensure minimum potential aeration over the acoustic window of the transducer. On twin drive installations, install the transducer between the drives.
On single drive installations, you should mount the transducer bracket on the side of the boat where the propeller blade is rotating downwards. This is usually the right (starboard) side. If possible, do not mount the
5