Wasp Bar Code WWS800, WWS850 user manual Introduction, Base Installation, Power Up the Base Station

Page 4

1.Introduction

This manual described how to operate and configure the WWS800/850 Wireless Barcode Scanner and is divided into two sections. The first section describes the installation, operation and programmable features of the scanner. The second section contains the setup barcodes used to configure the scanner.

•Barcode Readability: Most popular barcode symbologies are supported including the newest RSS Code.

•Negative barcodes supported.

•Eight scan modes supported.

•Programmable Beeping Tone

•Dual Color Indicator

•Interface Support (base unit): KB Wedge, RS232, and USB

•Bluetooth Serial Port Profile Supported: The scanner can transmit scanned data to Bluetooth enabled computer/PDA via standard Bluetooth Serial Port communication.

•Bluetooth HID Supported: The scanner can transmit scanned data to Bluetooth enabled computer/PDA via standard HID communication.

•Programmable Code ID: Code ID can be individually configured for each symbology.

•Programmable Length Code

•Programmable Prefix Code

•Programmable Postfix Code

•Character Substitution

•Data Editing: Data can be reorganized according to user programmable formats. Up to three data editing formats are supported.

•Extremely Low Power Consumption

2.Base Installation

The WWS800/850 kit contains:

A WWS800/850 wireless barcode scanner A base

A rechargeable battery

A Serial/Keyboard/USB Cable (depending on configuration ordered) A power supply for the base or the scanner.

Diskette containing “Scan Manager” and this manual

Note: Please refer to chapter 5 Bluetooth Serial Port for Bluetooth Serial Port installation and configuration instructions.

2.1Power Up the Base Station

Connect the interface cable into the 15-pin connector at the back of the base. There are three types of cables available: RS232, Keyboard or USB.

Power off your PC or Laptop when connecting the cable to your PC or Laptop. Once your cable is connected to the base, plug the other end into the appropriate port on your PC. For example, if you have a serial cable, plug it into the com port of your PC, if you have a Keyboard cable, plug it into the keyboard port of your PC and if you have a USB cable, plug it into the USB port on your PC.

Connect the power supply provided to your AC outlet and plug the other end into the base, then power on your PC.

Now you are ready to configure your scanner and base.

1 2

Page 3 Page 5
Image 4
Page 3 Page 5
Contents User’s Manual Table of Contents Data Output Format Power Up the Base Station Base InstallationIntroduction Power Up the WWS800/850 Setup RF ConnectionBattery Charging your WWS800/850General Features Interface SettingIndicator BuzzerRe-read Delay Supported SymbologiesAuto-Sense Scanner Time-out DurationOutput Interface Base Unit Negative BarcodesKeyboard Wedge Interface Keyboard Style AlphabetsUSB Interface RS232 InterfaceMemory Parameters Bluetooth Serial Port Configuring WWS800/850Bluetooth HID Update SettingsTimeout Activate Bluetooth HID InterfaceReset Connection HID Keyboard InterfaceConfiguring Bluetooth Device Driver Windows XP with Service Pack2Widcomm Bluetooth Driver Click Find Bluetooth Devices icon at My Bluetooth PlacesSymbology Parameters Code39Italy / French Pharmacode Industrial / Interleave / MatrixCodabar UpceEAN8 UpcaTelepen Plessey12 RSS Data Output Format Character SubstitutionPrefix / Postfix Code Code IDData Editing Additional Fields Field Transmission SequenceEnd of Format Programming Activate Data Editing FormatsConfiguring your WWS800/850 Enter Configuration ModeDefault List SettingExit Configuration Mode Key Type/Status Setting
Top Page Image Contents