Wasp Bar Code CCD Scanner manual Appendix B

Page 34

Appendix B

ASCII TABLE

Use this ASCII Table to add preamble and postamble characters to your barcode value. Please refer to the appropriate configuration section for the number of characters that can be configured.

NUL	LF	DC4
SOH	VT	NAK
STX	FF	SYN
ETX	CR	ETB
EOT	SO	CAN
ENQ	SI	EM
ACK	DLE	SUB
BEL	DC1	ESC
BS	DC2	FS
HT	DC3	GS

32

Image 34

Contents Programming Guide CCD Scanner Programming Guide Table of Contents Introduction Barcode Symbologies Installation WCS3900 PS2 ScannerQuick Start Setup & Configuration To change Minimum/Maximum LengthChapter Beep Settings Interblock Delay UPPER/LOWER Case Keyboard Language PREAMBLE/POSTAMBLE Configuration Terminator Enable ENABLE/DISABLE Barcode SymbologiesENABLE/DISABLE Barcode Symbologies Code 39 Settings Interleaved 2 of 5 and Code 93 Settings Code 128 and UCC/EAN 128 Settings Disable CodeMSI Plessey Settings Codabar Settings UPC-A Settings UPC-A Supplement Settings / UPC-A to EAN-13 UPC-E Settings UPC-E Supplement Settings EAN-8 Settings EAN-8 Supplement Settings EAN-13 Settings EAN-13 Supplement Settings Barcode Test Symbols Appendix a Appendix a Barcode Test Symbols EAN/JAN-13 Appendix B Appendix B Eps DEL Appendix C Function Code for PC Technical Specifications Appendix D OpticalWarranty Information FAQ Product Support Wasp Barcode Technologies Wasp Barcode Technologies