Wasp Bar Code WWR2900 manual Faq

Page 41

FAQ

Q:How do I configure the WWR2900 / 2905 Scanners for a notebook (or laptop) computer?

A:Scan the “Notebook” barcode on page 7.

Q:How do I change the terminator to a Tab?

A:Scan the “Tab” barcode on page 13.

Q:How do I remove the terminator?

A:Scan the “None” barcode on page 13.

Q:How do I enable the Full ASCII character set for the Code 39

barcode symbology?

A:Scan the following “Enable Code 39 Full ASCII” barcode on page 16.

39

Image 41
Contents Programming Guide Pen Scanner Programming Guide Table of Contents Introduction Barcode Symbologies Installation Quick Start Setup & Configuration Chapter Beep Settings Interblock Delay UPPER/LOWER Case Keyboard Language PREAMBLE/POSTAMBLE Configuration Terminator ENABLE/DISABLE Barcode Symbologies EnableENABLE/DISABLE Barcode Symbologies Code 39 Settings Interleaved 2 of 5 and Code 93 Settings Disable Code Code 128 and UCC/EAN 128 SettingsMSI Plessey Settings Codabar Settings UPC-A Settings UPC-A Supplement Settings UPC-E Settings UPC-E Supplement Settings EAN-8 Settings EAN-8 Supplement Settings EAN-13 Settings EAN-13 Supplement Settings Barcode Test Symbols Appendix a Appendix a Barcode Test Symbols EAN/JAN-13 Appendix B Appendix B Eps DEL Appendix C Function Code for PC Optical Technical Specifications Appendix DWarranty Information FAQ Product Support Wasp Barcode Technologies Wasp Barcode Technologies