Wasp Bar Code WWR2900 manual Quick Start

Page 7

Chapter 4

Quick Start

Your Wasp WWR2900 / 2905 Scanners are ready for use. The default settings of the Wasp WWR2900 / 2905 Scanners have been pre- programmed for the most common barcode configurations. Use the “WWR2900 / 2905 Scanners Setup & Configuration” sections only to customize the Wasp WWR2900 / 2905 Scanners settings. Please review the “Enable Barcode Symbologies” configuration beginning on page 14 to see the list of barcode symbologies which are enabled by default.

Tip:

•Use the pre-printed “Barcode Test Symbols” in Appendix A on pages 29-31 as a test chart to practice scanning.

PS2 Connection

USB Connection

5

Image 7

Contents Programming Guide Pen Scanner Programming Guide Table of Contents Introduction Barcode Symbologies Installation Quick Start Setup & Configuration Chapter Beep Settings Interblock Delay UPPER/LOWER Case Keyboard Language PREAMBLE/POSTAMBLE Configuration Terminator ENABLE/DISABLE Barcode Symbologies EnableENABLE/DISABLE Barcode Symbologies Code 39 Settings Interleaved 2 of 5 and Code 93 Settings Disable Code Code 128 and UCC/EAN 128 SettingsMSI Plessey Settings Codabar Settings UPC-A Settings UPC-A Supplement Settings UPC-E Settings UPC-E Supplement Settings EAN-8 Settings EAN-8 Supplement Settings EAN-13 Settings EAN-13 Supplement Settings Barcode Test Symbols Appendix a Appendix a Barcode Test Symbols EAN/JAN-13 Appendix B Appendix B Eps DEL Appendix C Function Code for PC Optical Technical Specifications Appendix DWarranty Information FAQ Product Support Wasp Barcode Technologies Wasp Barcode Technologies