Weber D4 Rotisserie Assembly, Install the motor bracket, Insert the rotisserie shaft in the motor

OPERATING INSTRUCTIONS 17

ROTISSERIE ASSEMBLY

Parts required: rotisserie motor bracket(1), rotisserie motor(1), rotisserie shaft(1), spit forks(4) and fork screws (4).

1)Install the motor bracket

Attach the stainless steel motor bracket to the left side of the cooking box, using the 1/4-20 fasteners and the 1/4-20 Keps nuts.

3)Put the spit forks on the rotisserie shaft.

Slide a spit fork from each side onto the shaft so that the tines are facing each other. Reverse forks to each other so that one fork screw is on top(1) and one is on the bottom(2), as shown in illustration. Screw in the split fork screws to hold the forks in place.

(1)

(2)

4)Insert the rotisserie shaft in the motor.

Insert the pointed end of the rotisserie shaft into the motor.

2)Attach the motor.

Slide the motor onto the motor bracket.

5)Set the rotisserie shaft onto rotisserie support block. Place the handle (3) end of rotisserie onto the support notch.

(3)