Z-Com XG-762N manual

Page 14

address of Station different.

The command to specify association address is very simple :

ifconfig ethX down

ifconfig ethX hw ether 01XXXXXXXXXX ; ifconfig ethX up

You must set the first byte = 01 to indicate this is for association address assignment only. The remainder XXXXXXXXXX is byte1-byte5 of PC¡¯s MAC address. Now, you can set up a bridge and add both wired and wireless interface. Then, you can try to ping to test the connectivity.

Image 14

Contents User Guide of XG-762N USB Linux Driver Introduction RequirementsBuilding the device driver Build and install the driverInstall individual driver Package ExtractionBuild the debugging tool Load the driver Configure the Wireless settingsGetting Start Open the network interfacePrivate commands Key/encryptionGet MAC mode Set authentication typeSet MAC mode Connect to the given Access PointDynamical Region SettingFor 802.11b/g only Activate MIC Fail Counter Measure FeatureGet IP setting from Dhcp Set up IP addressFixed Setting Setting Access PointSetup the Linux wpa supplicant Working with Linux WPA supplicantId.pem is created by Page Special Mode for Embedded Station Chariot Test Customization of VID/PID TablePage Turbo Mode Enable Burst ModePage Conclusion