Z-Com XG-762N manual

Page 16

the last frame from that station is a large packet. Therefore, AP can accept station capable of large packet or not. In Station mode, You need to re-associate with the AP to update your Turbo Mode status.

You need to remind something in mind. Large packet needs to merge two frames into one. In other words, when there is only one frame in queue, it could take some time to wait another one. If the next one comes too late or not come, it will be sent by a expire checking timer. It could result in lower performance than normal mode. Our experience shows two traffic flows achieve best performance. Fragmentation isn¡¯t allowed when Large Packet is on.

16

Image 16
Contents User Guide of XG-762N USB Linux Driver Introduction RequirementsBuild and install the driver Install individual driverBuilding the device driver Package ExtractionBuild the debugging tool Configure the Wireless settings Getting StartLoad the driver Open the network interfacePrivate commands Key/encryptionSet authentication type Set MAC modeGet MAC mode Connect to the given Access PointDynamical Region SettingFor 802.11b/g only Activate MIC Fail Counter Measure FeatureSet up IP address Fixed SettingGet IP setting from Dhcp Setting Access PointSetup the Linux wpa supplicant Working with Linux WPA supplicantId.pem is created by Page Special Mode for Embedded Station Chariot Test Customization of VID/PID TablePage Turbo Mode Enable Burst ModePage Conclusion