Z-Com XG-762N manual Build the debugging tool

Page 4

make clean

make XG-762NREV_B=0

make XG-762NREV_B=0 install

to install the driver.

2.4 Build the debugging tool

There are two debugging tools in this package, ¡°apdbg¡±and ¡°menudbg¡±.Run ¡°make debug¡±to compile them both. If you don¡¯t have the ncurse library, you may get some error messages while compiling menudbg. You can ignore it and get apdbg only.

4

Image 4
Contents User Guide of XG-762N USB Linux Driver Introduction RequirementsBuild and install the driver Install individual driverBuilding the device driver Package ExtractionBuild the debugging tool Configure the Wireless settings Getting StartLoad the driver Open the network interfacePrivate commands Key/encryptionSet authentication type Set MAC modeGet MAC mode Connect to the given Access PointDynamical Region SettingFor 802.11b/g only Activate MIC Fail Counter Measure FeatureSet up IP address Fixed SettingGet IP setting from Dhcp Setting Access PointSetup the Linux wpa supplicant Working with Linux WPA supplicantId.pem is created by Page Special Mode for Embedded Station Chariot Test Customization of VID/PID TablePage Turbo Mode Enable Burst ModePage Conclusion