Acumen SDR2-USB manual Copyright

Page 3

Copyright

This document is copyrighted by Acumen Instruments Corporation with all rights reserved. No part of this document may be reproduced in any form without prior written consent of Acumen Instruments Corporation.

Copyright © 2009 by Acumen Instruments Corporation. All rights reserved.

Disclaimer

This manual has been thoroughly reviewed for accuracy, and every effort has been made to ensure that the information is accurate and complete. However, different versions of this product have different features and capabilities, and this manual only reflects one of those versions. Therefore, Acumen Instruments Corporation assumes no responsibility for errors, omissions or defects in this material, and shall not be liable for any damages resulting from their use.

The information in this document is subject to change without notice.

ACUMEN INSTRUMENTS CORPORATION MAKES NO WARRANTY OF ANY KIND WITH RESPECT TO THIS DOCUMENT, EITHER EXPRESSED OR IMPLIED, INCLUDING WITHOUT LIMITATION ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

Image 3
Contents Acumen Instruments Corporation Page Copyright Page Table of Contents Service and Support Overview Getting StartedQuick guide to the DataBridge SDR2-USB Before you startConnecting power to your SDR2-USB Configuring your SDR2-USB via the setup fileDeploying the DataBridge SDR2-USB Congratulations Creating setup.txtSDR2-USB Configuring DataBridgeComments Setting date and timeSetting date and time Configuring the data portSpecifying a filename and folder Adding time stamps to recorded files Configuring file creation behaviorTesting your configuration Receiving data Setup file readingRecord mode operation OperationsFilename generation Power failure and improper shutdownsStopping recording Device removal while recordingPartitions Formatting the storage mediaResetting to factory defaults Lithium battery maintenanceInitial Setup Commands Setup File ReferenceRecording Behavior Commands Data Port Setup CommandsTime Stamping Commands Scheduled File Closing CommandsOther Commands Location J4 Remote Control PortPinout and Mating Cable FunctionsForce-Record Shunt Installation Page Exception Codes Service SupportService and Support SDR2-USB Configuration Guide rev Returning Equipment Contacting Acumen Instruments CorporationLimitations WarrantyOne year warranty ExclusionsSerial specifications Serial Port BasicsData rates Data rates and the Uart More asynchronous serial parametersDTE and DCE Voltage levels HandshakingSDR2-USB Configuration Guide rev Page Specifications Electrical specifications5 J7 rear power receptacle pin configuration USB socket Mechanical Specifications6 J1 power receptacle pin configuration Serial communicationsSpecifications SDR2-USB Configuration Guide rev