Acumen manual Service and Support SDR2-USB Configuration Guide rev

Page 30

Service and Support

SDR2-USB Configuration Guide rev 1.0

Exception 4: Bad Boot Record

Occurs when the disk is completely unformatted or formatted for an unsupported file system.

Use format /FS:FAT from the Windows command prompt to ensure proper FAT formatting.

Exception 5: Hardware Error

Usually occurs when the SDR2-USB cannot reset the USB storage device. Try ejecting and reinserting the card or using a new card and contact Acumen if problem persists.

Exception 6: EEPROM Error

Rare hardware error. Contact Acumen to discuss repair or replacement.

Exception 7: Cache Error

Rare hardware error. Contact Acumen to discuss repair or replacement.

Exception 8: Buffer Error (firmware error)

Rare error that may occur in customized or beta firmware versions. Contact Acumen to report.

Exception 9: Tasking Error (firmware error)

Rare error that may occur in customized or beta firmware versions. Contact Acumen to report.

Exception 10: USB Error

The USB storage media has reported a fatal error to the SDR2-USB.

Reinsert/replace the media and contact Acumen if problem persists.

Exception 11: Directory Creation Error

Rare. The SDR2-USB cannot create the subdirectory files are to be recorded to. Try using a different directory name or reformatting the media.

Exception 12: FAT12 File System Detected

The SDR2-USB has determined that the USB media was formatted using the FAT12 file system, which is unsupported. Reformat the USB storage device using the /A:512 option (Windows 2000/XP) and retry.

28

Page 29 Page 31
Image 30
Page 29 Page 31
Contents Acumen Instruments Corporation Page Copyright Page Table of Contents Service and Support Getting Started OverviewBefore you start Quick guide to the DataBridge SDR2-USBConnecting power to your SDR2-USB Configuring your SDR2-USB via the setup fileDeploying the DataBridge SDR2-USB Creating setup.txt CongratulationsConfiguring DataBridge SDR2-USBSetting date and time CommentsConfiguring the data port Setting date and timeSpecifying a filename and folder Configuring file creation behavior Adding time stamps to recorded filesTesting your configuration Operations Setup file readingRecord mode operation Receiving dataDevice removal while recording Power failure and improper shutdownsStopping recording Filename generationFormatting the storage media PartitionsLithium battery maintenance Resetting to factory defaultsSetup File Reference Initial Setup CommandsData Port Setup Commands Recording Behavior CommandsScheduled File Closing Commands Time Stamping CommandsOther Commands J4 Remote Control Port LocationFunctions Pinout and Mating CableForce-Record Shunt Installation Page Service Support Exception CodesService and Support SDR2-USB Configuration Guide rev Contacting Acumen Instruments Corporation Returning EquipmentExclusions WarrantyOne year warranty LimitationsSerial specifications Serial Port BasicsData rates More asynchronous serial parameters Data rates and the UartDTE and DCE Handshaking Voltage levelsSDR2-USB Configuration Guide rev Page Specifications Electrical specifications5 J7 rear power receptacle pin configuration Serial communications Mechanical Specifications6 J1 power receptacle pin configuration USB socketSpecifications SDR2-USB Configuration Guide rev
Top Page Image Contents