Outback Power Systems FW-IOB-D-120VAC installation instructions Requirements and Warnings

Page 3

Requirements and Warnings

The OutBack FW-IOB-D-120VAC is intended as a system compo- nent and is included in a listing by ETL as indoor enclosures to UL standard UL 508A Industrial Control Panels.

This enclosure is intended for battery circuits confi gured for 12 to 48 volts nominal.

Grounding Instructions – Each enclosure should be connected to a grounded, permanent wiring system. For most installations, the negative battery conductor should be bonded to the grounding system at one (and only one) point in the DC system. All instal- lations must comply with all national and local codes and ordi- nances. System grounding as required by the National Electric Code, ANSI /NFPA 70-1996, is the responsibility of the system installer.

The equipment ground is marked with this symbol:

2

Image 3 Outback Power Systems FW-IOB-D-120VAC Requirements and Warnings, Equipment ground is marked with this symbol
Contents FW-IOB-D-120VAC Date and Revision Requirements and Warnings Equipment ground is marked with this symbolFW-IOB-D-120VAC Parts List Placement of Bus Bars Sample Wiring Diagram AC Breaker Installation for FW-IOB-D-120VAC Installing the FW-IOB-D-120VACInstalling the AC Breaker Bypass Slide Plate