Outback Power Systems installation instructions Installing the FW-IOB-D-120VAC

Page 7

Installing the FW-IOB-D-120VAC

Dual-Pole Bypass Breaker Output Breakers Input Breakers (installed upside down)

Figure 4: AC Breaker Installation for FW-IOB-D-120VAC

To install the FW-IOB-D-120VAC:

Remove the appropriate quantity of breaker knockouts from the breaker bracket.

Pull the yellow tabs out from each breaker.

Install the breakers on the din rail to approximately match the openings in the breaker bracket.

Hold the breaker bracket loosely against the breakers on the din rail; move the breakers as needed so they line up with the openings in the breaker bracket.

With the breakers positioned properly, lock the yellow tabs to secure the breakers to the din rail.

Install the AC Breaker Bypass Slide Plate (see Figure 5).

6

Image 7 Outback Power Systems Installing the FW-IOB-D-120VAC, AC Breaker Installation for FW-IOB-D-120VAC
Contents FW-IOB-D-120VAC Date and Revision Requirements and Warnings Equipment ground is marked with this symbolFW-IOB-D-120VAC Parts List Placement of Bus Bars Sample Wiring Diagram AC Breaker Installation for FW-IOB-D-120VAC Installing the FW-IOB-D-120VACInstalling the AC Breaker Bypass Slide Plate