SIIG 04-0600B manual Hole Mounting

3.Engage the hex key hole nut into the key hole slot.

4.Put tension on the assembly by gently pulling back on the speaker mount post while tightening the 8-32 x 5/8" machine screw, see Figure 4 on page 5.

5.The hex key hole nut will engage on the housing in the key hole slot.

6.If the post does not tighten securely against the housing, it will be necessarry to use the M5 x 1/8" plastic washer as a spacer under the head of the 8-32 x 5/8" machine screw, see Figure 4 on page 5.

2/4 Hole Mounting

1.Find the best mounting configuration that matches your speaker enclosure. Four-hole mount patterns can be accomodated by positioning the speaker plate diagonally, see Figure 5 on the next page.

2.Using the 1/4"-20 x 1/2" machine screws, install the speaker plate and secure the speaker enclosure, see Figure 5 on the next page.

6