Panasonic DP-1810F manual Adding the Toner and Replacing Toner Waste Container ?, Cap

Page 39

Problem Solving/U13

Adding the Toner and Replacing Toner Waste Container (?)

1	Open the Front Cover.
	Open the Front Cover.
2	Remove the Toner Waste Container by
	Remove the Toner Waste Container by
	slowly pulling it towards the left as
	illustrated.

3

Cap

Seal the container with the enclosed cap and dispose of it properly.

4	1
	1
	2

#Turn the empty Toner Bottle

counter-clockwise until it stops. The Arrow mark (Unlocked symbol ) visible on the end of the Toner Bottle is aligned with the Arrow

mark on the machine.

Note: To prevent toner spill, ensure that the key is facing upwards before removing the toner bottle.

$Pull the empty Toner Bottle out. Note: If the bottle will not pull out from

the machine, turn the bottle slightly in either direction to release the key and try it again.

J

?

ATTENTION	CFor optimum copy quality use the recommended Panasonic toner. Store toner in a cool
	dark place. Do not unseal toner before use. Use it as fast as possible after unsealing.

CWhen U13 is displayed the Add Toner Warning Indicator will begin to flash. This message is to prompt you that the toner bottle is nearly empty (approx. 300-sheets can be printed). This message will continue to be displayed until the bottle is replaced. When the count- down counter reaches 0, the copier will stop operating. To clear the message and enable the copier to operate, replace the empty toner bottle with a new one.

39

Image 39

Contents Before Starting OptionsEnglish Others Model and Serial Number Important InformationCommon Features and Usage Operation ChartEnergy Star Table of Contents Problem Solving OptionsOthers Manufacturer’s name and address Factory ID PrecautionsFor Your Safety Laser SafetyToner and Paper Ventilation HandlingFCC Warning For U.S.A InstallationControl Panel Original Size Key Contents Refer to Interrupt Key, Memory in Key, M1/M2 KeysAlarm LED Red Copy Size Key$Select Exposure Control Basic CopyFull Size Copying Copying the Same Size OriginalsCopying with Preset Ratios Reduction or Enlargement CopyingPaper Tray key ADF Tray Original Guides Automatic Document Feeder# Automatic Original Feeding $2 in 1 CopyInappropriate Originals Face-UpZoom Copying ZoomSelect Original Using the Sheet Bypass $Adjust the side guidesCopying on Special Paper, etc 1 key Creative FeaturesProcedure 1 CopyCopy Or Margin key Press BOOK, Edge$Press the Memory in F2 key Job MemoryTo Store a Job in Memory To Recall a Job Stored in MemoryFrom Platen Glass only Sort ModeSort Copy Sort CopySleep Mode Other FeaturesEnergy Saver/Interrupt Mode Energy Saver ModeNormal Skyshot ModeDigital Skyshot Mode NonePlaten Upper Left Corner Manual Skyshot ModeOriginal Copy Combined Function TableOther Remarks Next Functions Job Memory Retrieval SelectionsFunction Using Function Modes to Change the Initial Copy ModesGeneral Functions Modes Function Initial SettingModes Function Copier SettingsGeneral Functions for Key Operator Copier Settings for Key Operator Function Setting Changing the Auto Exposure SettingProceed as Follows Function Setting for Key Operator Changing the Paper SizeFunctions Size IndicatorPaper Stopper Guide a Paper Guide bDepartment Counter DEPT. Counter ModeSelect the Department Counter Mode Components AccessoriesProblem Solving Adding Paper JSheet Paper Tray Cap Adding the Toner and Replacing Toner Waste Container ?Problem Solving Paper Misfeed Locations Removing a Misfed PaperPaper Exit Area Surface Paper Entry/Transport AreaHot HeatedPaper Feed Module ADF Unit Does Not Operate TroubleshootingBefore Calling Service Check ActionAdd Toner Warning Indicator Light CopiesMarked Copies User Error Codes U Code Replacing the Battery Battery Replacement Required MessageBattery Replacement Procedure DP-1810F Copier Specifications3rd Paper Feed Module DA-DS183 2nd/4th Paper Feed Module DA-DS182For Network Printing / Email Internet Fax Options and SuppliesFor Printer For FaxMemo Warranty

Related manuals

Manual 155 pages 18.62 Kb