Panasonic AV-HS300G Setup, Setting the input signals, 4

*/

0
*/
0
*/
*/
*/

3. Setup

3-1. Setting the input signals

3-1-1. Setting the input signals (IN 1 to 5)

If HD has been selected as the system format, SDI or analog HD component can be selected for each input. This selection is possible only when the HD analog board has been connected.

1Press the [FUNC] switch to light its indicator, and then press the [SETUP] switch to display the SETUP menu.

2Turn [F1] to display the IN1 to 5 menu.

3Turn [F2], select the input signals using the SIG item, turn [F3], and select SDI or ANLG (analog HD component) using the MODE item.

4If analog HD component has been selected, turn [F4], and set the gain of the input signals using the GAIN item. The gain can be set within the 30-step range, and the setting will result in changes of 2 dB.

The amount by which the gain changes per step is not the same for each step.

IN1-5 SIG 1/15 IN1

MODE GAIN

SDI -

IN2 ANLG -30—30

IN3

IN4

IN5

3-1-2. Setting the input signal frame synchronizer

The frame synchronizer can be set to ON or OFF for each input.

The input 6 (DVI input) frame synchronizer is permanently ON. It cannot be set from ON to OFF or vice versa.

1Press the [FUNC] switch to light its indicator, and then press the [SETUP] switch to display the SETUP menu.

2Turn [F1] to display the FS menu.

3Turn [F2], select the input signals using the SIG item, turn [F3], and select ON or OFF for the frame synchronizer using the FS item.

'4 4*( '4

*/

0/

*/
0''
*/
*/
*/

AVDL function is active while the frame synchronizer function is set to OFF.

The AVDL function automatically adjusts the input image signal phase to the horizontal synchronization reference signal phase.

For details, refer to “3-6. Adjusting the output signal phase”.

28