Handling and Maintenance
Appendix Troubleshooting Useful Information Getting Started
CAUTION
You will be unable to set [Computrace (R) BIOS Module] to [Disable] once you have set to [Enable]. Do not change the setting when not used.
•Even if you have set [Computrace (R) BIOS Module] to [Enable], this setting may return to [Disable] after repairs to the motherboard, etc. have been made.
NOTE
Consult Absolute Software Corp. before disposal.
Refer to the following URL for Computrace® software for installation and available service regions. Note that this service is only available in certain regions.
http://www.absolute.com
1 Turn on or restart the computer, and press F2 while [Panasonic] boot screen is dis- played.
The Setup Utility starts up.
If the password is requested, enter the Supervisor Password.
2Select the [Security] menu, then select [Computrace (R)
3Select [Computrace (R) BIOS Module], and set to [Enable].
4At the confirmation message, select [Execute] and press Enter.
5At the reconfirmation message, select [Execute] and press Enter.
6Press F10.
At the confirmation message, select [Yes] and press Enter.
The computer restarts.
Maintenance
To clean display (LCD)
Use the soft cloth included with the computer (For more information, refer to “Suggestions About Cleaning the LCD Sur- face” that comes with the soft cloth.)
Cleaning the display while the power is on may cause the computer to malfunction. Also, dirt on the touchscreen is eas- ier to see when the computer is powered off, and so is easier to clean.
To clean the touch pad
Wipe lightly with a gauze or other dry, soft cloth.
To clean areas other than the LCD panel and touch pad
Wet a soft cloth with water or a diluted kitchen cleanser (neutral), wring the cloth out thoroughly, and wipe the dirty area gently. Using a detergent other than a neutral kitchen cleanser (e.g., a weak alkali cleanser) may adversely affect painted surfaces.
CAUTION
Do not use benzene, thinner, or rubbing alcohol since it may adversely affect the surface causing discoloration, etc. Do not use
Do not apply water or detergent directly to the computer, since liquid may enter inside of the computer and cause malfunction or damage.
20