Basic Operation
Switching the projector on/off
Power cord
JJ Connecting
111 Make sure the shape of the power plug and the AC IN terminal on the back of the projector match, then push the plug all the way in.
222 Align the side of the power cord secure lock with the side guide rail of the AC IN terminal of the projector and slide it in.
Rail guide
JJ Disconnecting
111 Unplug the power cord from the wall outlet.
222 Depress the latch and slide the cover off.
333 Place the latch to the latch catcher and press until it clicks.
Latch 
444 Connect the power cord to a wall outlet.
333 Slide the power cord secure lock up along the side guide rail.
444 Hold the plug and unplug it from the AC IN terminal on the back of the projector.
Basic Operation
NOTE:
•• Do not use other than the provided power cord.
•• Ensure all the input devices are connected and turned off before connecting the power cord.
•• Do not force the connector as this may damage the projector and/or the power cord.
•• Dirt or dust
•• Switch off the power to the projector when not in use.
Power indicator
Power indicator informs you of the status of the power.
When the TEMP indicator is flashing, the power indicator will turn red, and you cannot switch on the power.
|
| Power indicator |
|
| |
|
|
| |||
|
|
| |||
Indicator status | Status | ||||
|
|
| |||
No illumination or flashing | MAIN POWER is switched off. | ||||
|
|
| |||
| Lit | MAIN POWER is switched on and the projector is in standby mode. | |||
|
|
| |||
|
| MAIN POWER is switched on (standby mode) and the POWER ON LINK is set to | |||
Red |
| YES. | |||
| Flashing | •• The power consumption is not much different when it is lit. | |||
|
| (See “VIERA Link Connection” of the functional instructions that is in the provided | |||
|
| CD‑ROM.) | |||
Green | Flashing | The power button is switched on and the projector is getting ready to project. | |||
|
|
|
| ||
Lit | Projecting. | ||||
| |||||
|
|
| |||
| Lit | The power button is switched off and the projector is cooling the lamp. | |||
Orange |
|
|
|
| |
Flashing | The power button is switched on again when cooling the lamp and recovering to | ||||
| |||||
| projection mode. Recovery may take a while. | ||||
|
| ||||
NOTE:
•• See “TEMP indicator” on page 25.
•• While the projector is cooling the lamp, do not switch MAIN POWER off or unplug the power cord.
•• The electric consumption in standby mode is 0.08 W.