Panasonic PT-F200NT, TH-LB50NT Wireless settings, Network/Security setting of the projector cont

Network/Security setting of the projector (cont.)

Wireless settings

Select [NEXT] on the IP address setting window to switch to the wireless setting window.

Make the settings related to the wireless connection between the projector and the network.

DETAILED SETUP

	USER1		2/3
	SSID	Panasonic Projector
	MODE		AD HOC
	AUTHENTICATION		OPEN
RETURN	ENCRYPTION		NONE
	CHANNEL		1
SELECT
ENTER	RETURN	NEXT	CANCEL

SSID※	: If the mode is [INFRASTRUCTURE※], enter the SSID registered at the access point. If the mode is
	[AD HOC], enter the same character string as that of SSID set on the computer to be connected.

SSID has to be entered in lower-case alphanumeric letters.

MODE	: Select [AD HOC] or [INFRASTRUCTURE].
AD HOC※	: Connect projector and computer directly without access point.
INFRASTRUCTURE※ : Connect through access point.
AUTHENTICATION	: Set the user authentication method used by the network to be connected.
OPEN	: Select when making a connection using [AD HOC], or when the access point authentication method is
	OpenSystem※.
SHARED	: Select when making a connection using [AD HOC], or when the access point authentication method is
WPA-PSK※	Shared Key※.
	: Select when the access point authentication method is WPA-PSK.
WPA2-PSK※	: Select when the access point authentication method is WPA2-PSK.

ENCRYPTION : Select the encryption method to be used for communication between the projector and the network.

NONE	: Select when transmit without encryption. It is selectable only when [AUTHENTICATION] is [OPEN] or
WEP※	[SHARED].
	: Select when ENCRYPTION is WEP.
TKIP※	: Select when ENCRYPTION is TKIP.
AES※	Selectable when [AUTHENTICATION] is either [WPA-PSK] or [WPA2-PSK].
	: Select when ENCRYPTION is AES.
	Selectable when [AUTHENTICATION] is either [WPA-PSK] or [WPA2-PSK].

※“Glossary” (See page 65)

•If you are unable to connect to the wireless LAN through the access point even after performing the steps in “A Projector settings (See page 22),” contact the manufacturer of the access point.

•IEEE802.1x is not supported.

•If you finished entering settings, press [NEXT].

49