Panasonic PT-AE700U Adjusting the position, Turning off the picture momentarily Shutter

Adjusting the position

When the input signal is from a PC, first select “AUTO SETUP” and then press the ENTER button to initiate automatic positioning.

If the optimum setting is not obtained when “AUTO SETUP” is carried out, adjust by the following procedure.

Press the F or G button to select an item, and then press the I or H button to change the setting.

Horizontal position (H-POSITION)

To move the picture to the left: I button

To move the picture to the right: H button

Vertical position (V-POSITION)

To move the picture down: I button

To move the picture up: H button

DOT CLOCK

(PC only)

BWhen YPBPR signals are being input, “CLOCK PHASE” can be adjusted only when

1 125 (1 080)/60i, 1 125

(1 080)/50i, 750 (720)/60p or 750 (720)/50p signals are being input.

ASPECT

Refer to page 30.

AUTO SETUP

(PC only)

“H-POSITION”, “V-POSITION”, “DOT CLOCK” and “CLOCK PHASE” are automatically adjusted according to the input signal.

NOTE:

BWhen the “ASPECT” is set to “V SCROLL” (page 30), “AUTO SETUP” cannot be performed.

For items with bar scales, press the ENTER button or the I or H button to display the adjustment screen, and then Press the I or H button to make the adjustment.

When an S-VIDEO/VIDEO/HDMI signal is being input

POSITION
H - POSITION	0
V - POSITION	0
ASPECT	16:9
SELECT ENTER	ESC

When a YPBPR signal is being input

POSITION
H - POSITION	0
V - POSITION	0
CLOCK PHASE	0
ASPECT	4:3
SELECT ENTER	ESC

When a PC signal is being input

POSITION
H - POSITION	0
V - POSITION	0
DOT CLOCK	0
CLOCK PHASE	0
ASPECT	4:3
AUTO SETUP
SELECT ENTER	ESC

Periodic striped pattern interference (noise) may occur when a striped pattern such as the one below is projected. If this happens, press the

Ior H button to adjust so that any such noise is minimised.

CLOCK PHASE

(PC/YPBPR only)

Adjust the “DOT CLOCK” setting first before carrying out this adjustment. Press the I or H button to adjust so that the noise level is least noticeable.

NOTE:

BIf signals with a dot clock frequency of 100 MHz or higher are being input, interference may not be completely eliminated when the “DOT CLOCK” and “CLOCK PHASE” adjustments are carried out.

Turning off the picture momentarily (SHUTTER)

The “SHUTTER” function can be used to momentarily turn off the picture
when the projector is not being used for short periods of time. The projector
uses less power in “SHUTTER” mode than it does in normal projection
mode.
	settings
#Select “SHUTTER” from the “MAIN MENU” and then press the
ENTER button.
$Press any button on either the projector or remote control unit	and
(except the LIGHT button) to return to normal operating mode.
	Adjustments
Changing the display language

#Select “LANGUAGE” from the “MAIN MENU” and then press the ENTER button.

$Press the F or G button to select a language and then press the

ENTER button.

LANGUAGE	ENGLISH	Indicates the language which is
ENGLISH		currently set
DEUTSCH
FRANÇAIS
ESPAÑOL
ITALIANO
SELECT ENTER	ESC

44-ENGLISH ENGLISH-45