Phoenix Gold IAMP-GM1 installation instructions Mounting the Subwoofer Enclosure And Amplifier

Phoenix Gold iSeries

7.Mounting the Subwoofer Enclosure And Amplifier

Step 1 – Install the supplied “L” shaped bracket to secure the iSeries enclosure. Locate the factory hole under the rear deck on the drivers side above the carpet (Fig A). Insert the supplied 3/8 x 1 ½ coarse thread bolt and 3/8 x 1 ¼ fender washer insert from the back side of the hole. Place a 1 ¼ fender washer, lock washer, and nut. Tighten securely (Fig B). Place the “L” bracket onto the bolt using the oval opening (not the round opening). Place the washer, lock washer then nut and tighten loosely (Fig C).

Fig. A
	Fig. B	Fig. C

Step 2 -Place iSeries subwoofer enclosure into the trunk with the narrow end pointing to the left (drivers side) of the trunk (Fig D). Slide at an angle into the location snug against the left (driver side) carpet taking care to avoid the rear left factory speaker. You have to slide it forward at an angle then slide the rear of the iSeries enclosure into position (Fig E & F).

Fig. D Fig. E Fig. F

Step 3 – Insert the supplied 3/8 x 1 coarse thread bolt, 3/8 x 1 ¼ fender washer and 3/8 lock washer into the mounting bolt location on the top of the iSeries subwoofer enclosure and tighten securely (Fig G). Now tighten the nut that attaches to the bolt installed earlier to hold the “L” bracket in place (Fig H).

10 Fig. Gwww.PHOENIXGOLD.comFig. H