Solution: If you have modified a partition on your solid state drive by using partition software, information about that partition, or the master boot record might have been destroyed.
1.Turn off the tablet, and then turn it on again.
2.If you still see only the cursor on the screen, do the following:
–If you have used the partition software, examine the partition on the solid state drive by using the software, and recover the partition if required.
–Use either the Rescue and Recovery workspace or the recovery discs to restore the system to the factory state.
If the problem persists, have the tablet serviced.
•Problem: My screen goes blank while the tablet is on.
Solution: Your screen saver or power management might have been enabled. Do either of the following:
–Touch the TrackPoint pointing device or the touch pad, or press a key to exit the screen saver.
–Press the power button to resume from sleep or hibernation mode.